Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM J

SEAT  SEAT HEATER SYSTEM  Seat Heater for Front Left Seat does not Operate  


DESCRIPTION

When the seat heater switch (front left side) is operated, the air conditioning amplifier assembly receives the signal. The air conditioning amplifier assembly receives the signal and operates the front left side seat heater.

WIRING DIAGRAM

E444468E13
0.198,4.813 1.792,5.177 1.594,0.365 10 false Air Conditioning Amplifier Assembly 2.083,4.51 3.313,5 1.229,0.49 10 false Seat Heater Control Sub-assembly LH 3.938,4.458 5.667,4.833 1.729,0.375 10 false Front Seat Cushion Heater Assembly LH 5.729,4.448 7.125,4.802 1.396,0.354 10 false Front Seatback Heater Assembly LH 0.719,5.396 2.49,5.583 1.771,0.188 10 false : LIN Communication Line 5.354,1 6.813,1.5 1.458,0.5 10 false Air Conditioning Control Assembly 1.948,1.094 2.823,1.375 0.875,0.281 10 false A/C NO. 3 3.167,0.969 4.688,1.156 1.521,0.188 10 false from A/C Relay 5.635,0.479 6.073,0.708 0.438,0.229 10 false LIN1 0.917,0.469 1.26,0.635 0.344,0.167 10 false LIN1 2.104,4.333 2.406,4.542 0.302,0.208 10 false L40 2.167,2.875 2.51,3.052 0.344,0.177 10 false +B1 2.177,3.906 2.563,4.083 0.385,0.177 10 false SWR 3.146,2.885 3.323,3.073 0.177,0.188 10 false E 2.906,3.917 3.396,4.094 0.49,0.177 10 false HTR1 0.188,4.656 0.573,4.833 0.385,0.177 10 false D79 0.823,3.927 1.281,4.094 0.458,0.167 10 false SM1L 1.302,3.792 1.51,3.969 0.208,0.177 10 false 13 1.948,3.792 2.094,3.958 0.146,0.167 10 false 5 1.969,2.771 2.115,2.938 0.146,0.167 10 false 1 3.344,2.76 3.552,2.938 0.208,0.177 10 false 10 3.365,3.792 3.51,3.979 0.146,0.188 10 false 7 4.167,3.802 4.385,4.083 0.219,0.281 10 false 1 4.135,2.76 4.479,3.146 0.344,0.385 10 false 6 4.146,1.833 4.51,2.271 0.365,0.438 10 false 2 3.927,4.229 4.292,4.469 0.365,0.24 10 false L35

CAUTION / NOTICE / HINT

NOTICE:
·

If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption Partial Limit on AC/Heater Operation" is displayed on the multi-information display in the combination meter assembly, inspect the auxiliary battery, referring to On-vehicle Inspection for the charging system.

Click herePower Source / Network>BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION

·

If the seat heater system is operated when the auxiliary battery voltage is low, due to the electrical load limit control that gives voltage supply priority to the power steering system, the seat heater system may not operate. In this case, check the vehicle control history of the power steering system and check that "Battery Voltage Drop: X208F" is not stored before proceeding with troubleshooting.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>VEHICLE CONTROL HISTORY

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (SEAT HEATER)
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Left Seat Heater LH side front seat heater operation OFF/ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Front Left Seat Heater
50004 121 117
OK:

LH side front seat heater operates normally.



Result:
Proceed to
OK
NG



OK

2.CHECK SEAT HEATER OPERATION

NG

3.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY LH - BATTERY)
2.CHECK SEAT HEATER OPERATION
a.

Check the seat heater operation.

Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK

OK:

The seat heater operates normally.



Result:
Result Proceed to
Does not operate normally with operation of either the multi-display or seat blower switch A
Does not operate normally with operation of the multi-display B
Does not operate normally with operation of the seat blower switch C



A

B

C

3.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY LH - BATTERY)
a.

Disconnect the L40 seat heater control sub-assembly LH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(L40)Location & Routing

Click Connector(L40)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly LH

L40-1 (+B1) - Body ground Ignition switch ON 11 to 14 V
L40-1 (+B1) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY LH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY LH)
a.

Disconnect the D79 air conditioning amplifier assembly connector.


b.

Disconnect the L40 seat heater control sub-assembly LH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D79,L40)Location & Routing

Click Connector(D79)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(L40)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly LH

D79-13 (SM1L) - L40-5 (SWR) Always Below 1 Ω
D79-13 (SM1L) or L40-5 (SWR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY LH - SEAT HEATER CONTROL SUB-ASSEMBLY LH AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY LH - SEAT HEATER CONTROL SUB-ASSEMBLY LH AND BODY GROUND)
a.

Disconnect the L35 front seat cushion heater assembly LH connector.


b.

Disconnect the L40 seat heater control sub-assembly LH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(L35,L40)Location & Routing

Click Connector(L35)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly LH

Click Connector(L40)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly LH

L35-6 - L40-10 (E) Always Below 1 Ω
L35-6 or L40-10 (E) - Body ground Always 10 kΩ or higher
L35-1 - L40-7 (HTR1) Always Below 1 Ω
L35-1 or L40-7 (HTR1) - Body ground Always 10 kΩ or higher
L35-2 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

6.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH

OK

7.INSPECT FRONT SEATBACK HEATER ASSEMBLY LH

NG

REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY LH

7.INSPECT FRONT SEATBACK HEATER ASSEMBLY LH

Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER>INSPECTION

Result:
Proceed to
OK
NG



OK

8.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY LH

NG

REPLACE FRONT SEATBACK HEATER ASSEMBLY LH

8.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY LH
a.

Replace the seat heater control sub-assembly LH with a new or known good one.

Click hereVehicle Interior>SEAT>SEAT HEATER CONTROL (for Front Seat)>REMOVAL


Result:
Proceed to
NEXT



NEXT

9.CHECK FRONT SEAT HEATER OPERATION
9.CHECK FRONT SEAT HEATER OPERATION
a.

Check the LH side front seat heater operation.

Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK

OK:

Front left side seat heater operates normally.



Result:
Proceed to
OK
NG



OK

END (SEAT HEATER CONTROL SUB-ASSEMBLY LH WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY