NAVIGATION SYSTEM > Radio Receiver Communication Error |
| 1.IDENTIFY COMPONENT SHOWN BY SUB-CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component shown by the sub-code.
| NEXT | |
| 2.CHECK POWER |
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| Gateway ECU (1C6) | Gateway ECU power source circuit (Click here) |
| Stereo component amplifier (440) | Stereo component amplifier power source circuit (Click here) |
| Multi-display (110) | Multi-display power source circuit (Click here) |
| Navigation ECU (178) | Navigation ECU power source circuit (Click here) |
| NEXT | |
| 3.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the R5 and R6 receiver connectors.
Measure the resistance of the receiver.
| Tester Connection | Specified Condition |
| R6-5 (TX+) - R6-15 (TX-) | 60 to 80 Ω |
| R5-9 (TX+) - R5-10 (TX-) | 60 to 80 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.
Disconnect all connectors between the radio receiver and the component shown by sub-code.
Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

|
| ||||
| OK | |
| 5.REPLACE COMPONENT SHOWN BY SUB-CODE |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||