Home › BRAKE › BRAKE CONTROL › SKID CONTROL ECU

SKID CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL ECU


    C127949
  1. Install the skid control ECU with the 3 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the 4 skid control ECU connectors.

  1. Install the wire harness clamp and skid control buzzer to the skid control ECU bracket.



2. INSTALL STEERING COLUMN ASSEMBLY
  1. Install the steering column (Click here).

    HINT:
    Refer to the procedures from the installation of the steering column assembly up until the installation of the No 2. rear floor board.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSPECT SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).



5. PERFORM SYSTEM INITIALIZATION
  1. Perform the brake system initialization (Click here).



6. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform the yaw rate sensor zero point calibration (Click here).



7. CHECK AND CLEAR DTC
  1. Check and clear the DTCs (Click here).