Perform "Inspection After Repair" after replacing the fuel injector assembly (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION).
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISCHARGE FUEL SYSTEM PRESSURE
58165F
3.REMOVE FRONT FLOOR COVER RH
4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
25680
5.REMOVE EGR VALVE WITH COOLER ASSEMBLY
47220D
6.SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (for RHD)
19500D
7.REMOVE NO. 1 IGNITION COIL
82121
8.SEPARATE ENGINE WIRE (for LHD)
82121
9.SEPARATE ENGINE WIRE (for RHD)
11201
10.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
23841B
11.REMOVE EFI FUEL PIPE CLAMP
Remove the EFI fuel pipe clamp.
23901
12.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel delivery pipe.
| *1 | Fuel delivery pipe |
| *2 | Fuel Tube Connector |
| *3 | Nylon Tube |
| *4 | O-ring |
| *5 | Retainer |
|
Pinch |
|
Pull |
Check for foreign matter on the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel delivery pipe.
Do not use any tools to separate the fuel tube connector and fuel delivery.
Do not forcibly bend, kink or twist the nylon tube.
Keep the fuel tube connector and fuel delivery pipe free from foreign matter.
If the fuel tube connector and fuel delivery pipe are stuck, push and pull to release them.
Put the fuel tube connector and fuel delivery pipe in plastic bags to prevent damage and contamination.
23814B
13.REMOVE FUEL DELIVERY PIPE
Remove the bolt.
Disengage the clamp to disconnect the wire harness.
Remove the 2 bolts and the fuel delivery pipe with the 4 fuel injectors.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
23891
14.REMOVE FUEL DELIVERY SPACER
Remove the 2 fuel delivery spacers from the cylinder head.
23291
15.REMOVE INJECTOR VIBRATION INSULATOR
Remove the 4 injector vibration insulators from the cylinder head.
23250
16.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 4 fuel injector assemblies out of the fuel delivery pipe.
|
Pull |
Remove the O-ring from each fuel injector.
For reinstallation, attach a tag or label to each injector shaft.
Prevent entry of foreign matter by covering the fuel injectors with plastic bags.