Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › 2014.12–2015.11
RM2170E _52 Drivetrain _057015 AXLE AND DIFFERENTIAL _0277999 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 42403 4.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>1NZ-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION).


b.

Connect the reservoir level switch connector.