Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the rear axle hub and bearing assembly (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION).
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
2.INSPECT REAR AXLE HUB BEARING LOOSENESS
3.INSPECT REAR AXLE HUB RUNOUT
42403
4.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
89516D
5.CONNECT SKID CONTROL SENSOR WIRE
Install the skid control sensor wire connector to the connector cover.
Engage the 3 claws to secure the connector cover.
Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.
6.INSTALL REAR WHEEL
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>1NZ-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION).
Connect the reservoir level switch connector.
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
8.INSPECT REAR WHEEL ALIGNMENT
9.CHECK FOR SPEED SENSOR SIGNAL