Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.
2.INSPECT REAR AXLE HUB BEARING LOOSENESS
3.INSPECT REAR AXLE HUB RUNOUT
42403
4.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
89516D
5.CONNECT SKID CONTROL SENSOR WIRE
6.INSTALL REAR WHEEL
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>1NZ-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION).
Connect the reservoir level switch connector.
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
8.INSPECT REAR WHEEL ALIGNMENT
9.CHECK FOR SPEED SENSOR SIGNAL