The circuit is used to send TRC and VSC information from the skid control ECU to the power management control ECU, and hybrid control system information from the power management control ECU to the skid control ECU via the CAN communication system.
Identification information sent from other ECUs is stored when shipped from the factory and used as default values.
DTC C1203/95 is output when an incorrect ECU is installed. If initialization is performed and learning occurs with an incorrect ECU installed, operations and functions will differ from that stored when the vehicle was shipped from the factory. Therefore, make sure that learning occurs properly.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1203/95 | - | Either of the following is detected:
1.
Identification information sent from other ECUs does not match with the value stored when shipped from the factory. 2.
No stored information for destination. |
·
The wrong ECU was installed ·
Skid control ECU (Brake booster with master cylinder assembly) |
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).
Check that the proper power management control ECU, main body ECU (multiplex network body ECU) and yaw rate and acceleration sensor (airbag sensor assembly) are installed.
Proper ECUs are installed.
Check if the power management control ECU, main body ECU (multiplex network body ECU) and yaw rate and acceleration sensor (airbag sensor assembly) were replaced before the DTC was recorded.
ECU were not replaced.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (A proper power management control ECU is not installed and/or the power management control ECU was replaced.) | B |
| NG (A proper main body ECU (multiplex network body ECU) is not installed and/or the main body ECU (multiplex network body ECU) was replaced.) | C |
| NG (A proper yaw rate and acceleration sensor (airbag sensor assembly) is not installed and/or the yaw rate and acceleration sensor (airbag sensor assembly) was replaced.) | D |
A
B
C
D
Perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).
Before performing initialization and calibration of the linear solenoid valve, C1203/95 will be output.
NEXT
Turn the power switch off (lock).
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
Turn the power switch on (IG).
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1203/95 is output (for LHD). | A |
| DTC C1203/95 is output (for RHD). | B |
| DTC C1203/95 is not output. | C |
A
B
C