Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057035 THEFT DETERRENT / KEYLESS ENTRY _0278082 ENGINE IMMOBILISER SYSTEM S

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


Certification ECU (Smart Key ECU Assembly)
DTC Code Detection Item Detection Enabling Condition (DTC Output Confirmation Operation) See page
B2784 Antenna Coil Open / Short With the shift lever in P, the key is held near the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the key battery is depleted. (Click here)
B278A Short to GND in Immobiliser System Power Source Circuit With the shift lever in P, the key is held near the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the key battery is depleted. (Click here)
B2790 ID BOX EEPROM Malfunction An immobiliser set/unset operation is performed (Turn the power switch is off or on (IG) while carrying the key). (Click here)

Power Management Control ECU
DTC Code Detection Item Detection Enabling Condition (DTC Output Confirmation Operation) See page
B2799 Engine Immobiliser System Malfunction Either condition is met:
- 10 seconds after a hybrid control system start operation (with the shift lever in P and the brake pedal depressed, the power switch is pressed while carrying the key). If there is a malfunction, the hybrid control system does not start (communication begins within 3 seconds of the hybrid control system start operation, and DTCs are stored after 6 seconds).
- 10 seconds after the power switch is turned on (IG) after reconnecting the cable to the negative (-) auxiliary battery terminal (communication begins within 3 seconds of the power switch being turned on (IG), and DTCs are stored after 6 seconds).
(Click here)
B279A Theft Deterrent System Communication Line High Fixation Turn the power switch on (IG) and wait 6 seconds. (Click here)
B279C Theft Deterrent System Presence Detection Check for DTCs. (Click here)