Home › Vehicle Interior › INTERIOR PANELS / TRIM › UPPER INSTRUMENT PANEL › 2015.11–2017.06
RM2170E _58 Vehicle Interior _057044 INTERIOR PANELS / TRIM _0278145 UPPER INSTRUMENT PANEL A

INTERIOR PANELS / TRIM  UPPER INSTRUMENT PANEL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

a.

When using a new instrument panel sub-assembly:

i.

Immediately before installing the upper instrument panel assembly, twist and cut off the portion shown in the illustration.

B301706



b.

Push the upper instrument panel assembly in the direction indicated by the arrow (1) to engage the 5 guides.

B301693E02
4.979,1.469 5.177,1.635 0.198,0.167 10 true (1) 4.5,2.125 4.698,2.292 0.198,0.167 10 true (2)


c.

Push the upper instrument panel assembly in the direction indicated by the arrow (2) to engage the 7 clips to install the upper instrument panel assembly.


d.

Install the bolt <A>.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


e.

Install the screw <C>.


f.

Install the 2 clips.


g.

w/ Navigation System:

i.

Connect the connector.



Hide 62211 3.INSTALL FRONT PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 62311B 4.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 62312B 6.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 55404D 8.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

Engage the 9 guides and 4 claws.


b.

Install the instrument cluster finish panel sub-assembly with the 2 clips.


Hide 55670A 9.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

a.

Engage the claw and 4 clips, to install the center instrument panel register assembly.


Hide 55474B 10.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH

a.
B301686

Engage the 10 guides and 12 clips to install the instrument cluster finish panel garnish.


Hide 55660 11.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

a.

Engage the 3 clips to install the No. 2 instrument panel register assembly.


Hide 55650 12.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

a.

Engage the 3 clips to install the No. 1 instrument panel register assembly.


Hide 55405B 13.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.
B301682

Engage the claw and 8 clips to install the center instrument cluster finish panel sub-assembly.


Hide 14.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).