Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2017.06
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278055 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1.REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

Hide 2.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

Hide 55840C 3.REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY

Hide 86101 4.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

for LHD:

i.

Disconnect each connector.


ii.

Remove the 2 bolts.

E244935


iii.

Disengage the 5 clamps and remove the antenna cord sub-assembly.



b.

for RHD:

i.

Disconnect each connector.


ii.

Remove the 2 bolts.

E247777


iii.

Disengage the 5 clamps and remove the antenna cord sub-assembly.



Hide 5.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86101J 6.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

w/o Coat Hook:

i.

Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

E373439C01
0,0 0,0 false
V100155

Tape
V100136

Front


HINT:

Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining assembly so that the tape can be reused.



ii.

Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.



b.

w/ Coat Hook:

i.

Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

E373440C01
0,0 0,0 false
V100155

Tape
V100136

Front


HINT:

Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining assembly so that the tape can be reused.



ii.

Disengage 3 clamps and remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.