Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEELS
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (Integrated Cover Type)
51442C
3.REMOVE ENGINE UNDER COVER LH (Separated Cover Type)
51441C
4.REMOVE ENGINE UNDER COVER RH (Separated Cover Type)
5.DRAIN HYBRID TRANSAXLE FLUID
43502H
6.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
89543
7.SEPARATE FRONT SPEED SENSOR
45047
8.SEPARATE TIE ROD END SUB-ASSEMBLY
48810
9.SEPARATE FRONT STABILIZER LINK ASSEMBLY
48069
10.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
43420
11.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
43420
12.REMOVE FRONT DRIVE SHAFT ASSEMBLY
Using SST, remove the front drive shaft assembly.
Do not damage the hybrid vehicle transaxle assembly type T oil seal.
Do not damage the inboard joint boot.
Do not drop the front drive shaft assembly.
43420G
13.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the front drive shaft hole snap ring.