48258C
1.INSTALL REAR LOWER COIL SPRING INSULATOR LH
Install the rear lower coil spring insulator LH onto the rear axle beam assembly.
48258B
2.INSTALL REAR LOWER COIL SPRING INSULATOR RH
Perform the same procedure as the LH side.
48259A
3.INSTALL REAR UPPER COIL SPRING INSULATOR LH
Install the rear upper coil spring insulator LH so that its gap fits onto the end of rear coil spring LH.
| *a | Fit |
48257C
4.INSTALL REAR UPPER COIL SPRING INSULATOR RH
Perform the same procedure as the LH side.
48231B
5.INSTALL REAR COIL SPRING LH
When replacing the rear coil spring LH or rear coil spring RH with a new one, make sure to check the part number and install it to the correct position.
When reusing the rear coil spring LH or rear coil spring RH, make sure to check its identification mark and install it to the correct position.
Support the spring seat of the rear axle beam assembly using 2 jacks and 2 wooden blocks.
Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Since stopper nuts are used, turn the bolts.
Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks.
Install the rear coil spring LH onto the rear axle beam assembly.
|
Paint Mark |
The paint mark of the rear coil spring LH should be towards the underside and rear side of the vehicle.
Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks, and temporarily install the rear axle beam assembly and rear coil spring LH with the 2 bolts and 2 nuts.
48231A
6.INSTALL REAR COIL SPRING RH
Perform the same procedure as the LH side.
47319F
7.INSTALL REAR FLEXIBLE HOSE LH
Install the rear flexible hose LH onto the rear axle beam assembly with a new clip.
Install the clip as far as it will go.
Using a union nut wrench, install the rear flexible hose LH to the brake tube while holding the rear flexible hose LH with a wrench.
Do not bend or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
47318F
8.INSTALL REAR FLEXIBLE HOSE RH
Perform the same procedure as the LH side.
89516D
9.INSTALL SKID CONTROL SENSOR WIRE LH
Install the skid control sensor wire LH to the rear axle beam assembly with the nut.
89516C
10.INSTALL SKID CONTROL SENSOR WIRE RH
Perform the same procedure as the LH side.
89516D
11.CONNECT SKID CONTROL SENSOR WIRE LH
89516C
12.CONNECT SKID CONTROL SENSOR WIRE RH
Perform the same procedure as the LH side.
13.INSTALL REAR WHEEL
14. STABILIZE SUSPENSION
42110F
15.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY
48540
16.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
48530
17.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
Perform the same procedure as the LH side.
18.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
19.BLEED BRAKE LINE
89407A
20.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)
21.INSPECT REAR WHEEL ALIGNMENT
22. CHECK SPEED SENSOR SIGNAL