Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FRAME WIRE › from 2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277932 FRAME WIRE A

HYBRID / BATTERY CONTROL  FRAME WIRE  REMOVAL  


PROCEDURE

Hide 51201 4.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 5.REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)

Hide 71033 6.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY

Hide G92F1 7.REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT

Hide G9230 8.REMOVE BATTERY COOLING BLOWER ASSEMBLY

Hide G92N1A 9.REMOVE NO. 1 HYBRID VEHICLE BATTERY COVER PANEL LH

Hide 10.DISCONNECT CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL

a.
A266722

Remove the connector cover.


b.
A266723

Remove the nut and disconnect the positive auxiliary battery terminal.


Hide 82164 11.REMOVE FRAME WIRE

CAUTION:

Wear insulated gloves.


NOTICE:

Insulate the disconnected terminals with insulating tape.


a.
A266763

Disconnect the connector.


b.
A266764E03
2.271,0.906 1.958,1.156 true 1.792,1.104 1.938,1.302 0.146,0.198 10 true *1

Disconnect the 2 connectors.

Text in Illustration
*1 Shielded Wire Ground


c.

Disconnect the shielded wire ground.


d.
A266725

Disconnect the 6 clamps.


e.
A266716

Disengage the claw and disconnect the frame wire from the engine room junction block assembly.


f.
A266717

Disconnect the clamp.


g.
A266720

Disconnect the clamp.


h.
A266718

Disconnect the clamp.


i.
A266719

Disconnect the clamp.


j.

Remove the 3 nuts.

A266721


k.

Disconnect the 4 clamps and remove the frame wire.

NOTICE:

The clamps are non-reusable parts.