47121
1.INSTALL BRAKE PEDAL PAD
47110
2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Install the nut to the brake pedal support assembly.
Install the brake pedal support assembly with the 4 nuts.
Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.
| *a | Bolt Width |
| Bolt Variation | Bolt Width |
|---|---|
| Bolt A | 14 mm (0.551 in.) |
| Bolt B | 12 mm (0.472 in.) |
Two types of bolts each with a different torque specification are used.
Engage the 2 clamps.
47264A
3.INSTALL PUSH ROD PIN
Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.
Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.
4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45260
5.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
Align matchmarks on the No. 2 steering intermediate shaft assembly and steering intermediate shaft.
| *a | Matchmarks |
Connect the No. 2 steering intermediate shaft assembly to the steering intermediate shaft.
Install the bolt.
45259A
6.INSTALL COLUMN HOLE COVER SILENCER SHEET
Install the column hole cover silencer sheet with the 2 clips.
Turn back the floor carpet.
47101A
7.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support assembly and push rod pin.
84345
8.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
84340
9.INSTALL STOP LIGHT SWITCH ASSEMBLY
89510D
10.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY
73900
11.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55045
12.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
58810J
13.INSTALL CONSOLE BOX ASSEMBLY
89650
14.INSTALL POWER STEERING ECU ASSEMBLY
15.INSPECT AND ADJUST BRAKE PEDAL
16. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE
55606
17.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY