Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Rear View Monitor System (for Navigation System) 
Symptom
Suspected Area
See page
When reverse (R) has been selected, an image of the area behind the vehicle is not displayed (screen is not black).
Reverse signal circuit (for Navigation receiver type)
Click here
Reverse signal circuit (for Radio and display type)
Click here
Navigation ECU sub-assembly (for Navigation receiver type)
Click here
Radio and display receiver assembly (for Radio and display type)
Click here
When reverse (R) has been selected, an image of the area behind the vehicle is not displayed (screen is black).
Navigation receiver assembly power source circuit (for Navigation receiver type)
Click here
Radio receiver power source circuit (for Radio and display type)
Click here
Image from Camera for Rear View Monitor is Abnormal
Click here
Navigation ECU sub-assembly (for Navigation receiver type)
Click here
Radio and display receiver assembly (for Radio and display type)
Click here
When a shift state other than reverse (R) has been selected, an image of the area behind the vehicle is displayed.
Reverse signal circuit (for Navigation receiver type)
Click here
Reverse signal circuit (for Radio and display type)
Click here
Navigation ECU sub-assembly (for Navigation receiver type)
Click here
Radio and display receiver assembly (for Radio and display type)
Click here
Image from the camera for the rear view monitor is abnormal (color, distorted image).
Image from Camera for Rear View Monitor is Abnormal
Click here
Navigation ECU sub-assembly (for Navigation receiver type)
Click here
Radio and display receiver assembly (for Radio and display type)
Click here
When an image of the area behind the vehicle is displayed, the lines are misaligned. (The image from the camera is tilted.)
Check that the camera is correctly installed
Click here

Rear View Monitor System (for Audio and Visual System) 
Symptom
Suspected Area
See page
When reverse (R) has been selected, an image of the area behind the vehicle is not displayed (screen is not black).
Reverse signal circuit (w/o Daytime Running Light)
Click here
Reverse signal circuit (w/ Daytime Running Light)
Click here
Radio and display receiver assembly (w/ Daytime Running Light)
Click here
Navigation ECU sub-assembly (w/o Daytime Running Light)
Click here
When reverse (R) has been selected, an image of the area behind the vehicle is not displayed (screen is black).
Radio receiver power source circuit (w/o Daytime Running Light)
Click here
Radio receiver power source circuit (w/ Daytime Running Light)
Click here
Image from Camera for Rear View Monitor is Abnormal
Click here
Radio and display receiver assembly (w/ Daytime Running Light)
Click here
Navigation ECU sub-assembly (w/o Daytime Running Light)
Click here
When a shift state other than reverse (R) has been selected, an image of the area behind the vehicle is displayed.
Reverse signal circuit (w/o Daytime Running Light)
Click here
Reverse signal circuit (w/ Daytime Running Light)
Click here
Radio and display receiver assembly (w/ Daytime Running Light)
Click here
Navigation ECU sub-assembly (w/o Daytime Running Light)
Click here
Image from the camera for the rear view monitor is abnormal (color, distorted image).
Image from Camera for Rear View Monitor is Abnormal
Click here
Radio and display receiver assembly (w/ Daytime Running Light)
Click here
Navigation ECU sub-assembly (w/o Daytime Running Light)
Click here
When an image of the area behind the vehicle is displayed, the lines are misaligned. (The image from the camera is tilted.)
Check that the camera is correctly installed
Click here