Home › Vehicle Interior › HEATING / AIR CONDITIONING › PTC HEATER ASSEMBLY
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0230757 PTC HEATER ASSEMBLY A

HEATING / AIR CONDITIONING  PTC HEATER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PTC heater assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 73900 1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 55406B 3.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 58816C 4.REMOVE FRONT NO. 1 CONSOLE BOX INSERT

Hide 87211 5.REMOVE NO. 1 AIR DUCT

Hide 87114L 6.REMOVE NO. 2 HEATER COVER

a.
E338274

Remove the screw.


b.

Disengage the claw and guide to remove the No. 2 heater cover.


Hide 87710G 7.REMOVE QUICK HEATER ASSEMBLY

a.

Release the tilt and telescopic lever and fully extend and upper the steering column assembly.


b.

Lock the tilt and telescopic lever.


c.

Disconnect each connector.


d.
E338275C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guide and remove the quick heater assembly as shown in the illustration.