Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM3210E _58 Vehicle Interior _047507 THEFT DETERRENT / KEYLESS ENTRY _0238440 THEFT DETERRENT SYSTEM T

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


HINT:
·

Troubleshooting of the theft deterrent system is based on the premise that the power door lock control system and the wireless door lock control system are operating normally. Accordingly, before troubleshooting the theft deterrent system, first make certain that the power door lock control system and the wireless door lock control system are operating normally.

·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Theft Deterrent System
Symptom Suspected Area Link
Theft deterrent system cannot be set Refer to "Security Indicator Light Does not Blink" Click here
Refer to "Front Door Courtesy Switch Circuit" Click here
Refer to "Rear Door Courtesy Switch Circuit" Click here
Refer to "Back Door Courtesy Switch Circuit" Click here
Front door lock with motor assembly Click here
Rear door lock with motor assembly Click here
Back door lock assembly Click here
Refer to "Engine Hood Courtesy Switch Circuit" Click here
Security indicator light does not blink when theft deterrent system is set Refer to "Security Indicator Light Does not Blink" Click here
Alarm sounding state cannot be canceled when power switch is turned on (IG) Refer to "Entry and Start System (for Start Function)" Click here
Certification ECU (Smart key ECU assembly) -
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
Theft deterrent system can be set even when door is open Refer to "Front Door Courtesy Switch Circuit" Click here
Refer to "Rear Door Courtesy Switch Circuit" Click here
Refer to "Back Door Courtesy Switch Circuit" Click here
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
Theft deterrent system can be set even when engine hood is open Refer to "Engine Hood Courtesy Switch Circuit" Click here
Vehicle horns do not sound while theft deterrent system is in alarm sounding state Refer to "Horn Circuit" Click here
Hazard warning lights do not flash while theft deterrent system is in alarm sounding state Combination meter assembly -
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
Security horn does not sound while theft deterrent system is in alarm sounding state*1 Refer to "Security Horn Circuit" Click here
Theft warning siren does not sound while theft deterrent system is in warning operation*2 Refer to "Theft Warning Siren Circuit" Click here
Hazard warning lights flash even when theft deterrent system is not set Combination meter assembly -
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
The vehicle does not enter the alarm sounding state in accordance with intrusion sensor operation*3 Refer to "Intrusion Sensor Circuit" Click here
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
Intrusion sensor cancel function does not operate*3 Combination meter assembly -
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) Click here
Glass breakage sensor does not operate*3 Refer to "Glass Breakage Sensor Circuit" Click here
The vehicle does not enter the alarm sounding state as the auxiliary battery is reconnected Check the auxiliary battery Click here
Refer to "Power Source Circuit" Click here

*1: w/ Security Horn Assembly

*2: w/o Security Horn Assembly

*3: w/ Intrusion Sensor