Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM3210E _54 Brake _047516 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0243383 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION

HINT:
·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

·

If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.




Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 4.INSTALL REAR DISC

Hide 5.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 46430 6.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 47658B 7.INSTALL PARKING BRAKE LEVER PROTECTOR

Hide 89516D 8.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.


Hide 9.ADJUST PARKING BRAKE

Hide 10.INSTALL REAR WHEEL

Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal.

Click herePower Source / Network>2ZR-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION


b.

Connect the reservoir level switch connector.


c.

Turn the power switch on (READY).


d.

Depress the brake pedal and release it.