Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM3210E _52 Drivetrain _047518 AXLE AND DIFFERENTIAL _0244651 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When removing or installing the rear disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 4.INSTALL REAR DISC

Hide 5.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 46430 6.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 47658B 7.INSTALL PARKING BRAKE LEVER PROTECTOR

Hide 89516D 8.CONNECT SKID CONTROL SENSOR WIRE

Hide 9.ADJUST PARKING BRAKE

Hide 10.INSTALL REAR WHEEL

Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the reservoir level switch connector.


b.

Connect the cable to the negative (-) auxiliary battery terminal.

Click herePower Source / Network>2ZR-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION


c.

Turn the power switch on (READY).


d.

Depress the brake pedal and release it.