The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle hub and bearing assembly removal/installation are shown below.
When removing or installing the rear disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISABLE BRAKE CONTROL
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
3.REMOVE REAR WHEEL
46441
4.LOOSEN NO. 1 WIRE ADJUSTING NUT
for LHD: Click hereBrake>PARKING BRAKE>PARKING BRAKE PEDAL(for LHD)>REMOVAL
for RHD: Click hereBrake>PARKING BRAKE>PARKING BRAKE PEDAL(for RHD)>REMOVAL
47658B
5.REMOVE PARKING BRAKE LEVER PROTECTOR
46430
6.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
7.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42431
8.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
89516D
9.DISCONNECT SKID CONTROL SENSOR WIRE
42450B
10.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.