Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE(for Rear Side)
RM3210E _54 Brake _047522 PARKING BRAKE _0243351 PARKING BRAKE CABLE(for Rear Side) A

PARKING BRAKE  PARKING BRAKE CABLE(for Rear Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 3 parking brake cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of heated oxygen sensor (w/ Canister Pump Module)

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


w/ Canister Pump Module:(Click here)
w/o Canister Pump Module:(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


HINT:

Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.


PROCEDURE

Hide 46441 1.LOOSEN NO. 1 WIRE ADJUSTING NUT

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 46410 3.SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY

Hide 46302 4.SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

a.
C345645

Separate the No. 1 parking brake pull rod sub-assembly from the No. 3 parking brake cable assembly as shown in the illustration.


Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 58153 6.REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR

a.
C345646

Remove the 4 nuts and front No. 2 floor heat insulator.


Hide 57628C 7.REMOVE REAR FLOOR SIDE MEMBER COVER LH (for LH Side)

Hide 58390 8.REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY (for RH Side)

Hide 47658B 9.REMOVE PARKING BRAKE LEVER PROTECTOR

a.
C345648

Remove the parking brake lever protector from the No. 3 parking brake cable assembly.


Hide 46430 10.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Remove the 4 bolts and nut, and separate the No. 3 parking brake cable assembly.

C345647


b.
C345649

Pull out the No. 3 parking brake cable assembly to the outside of the vehicle body.


c.
C345654

Separate the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.


d.
C345655C02
1.344,1.188 2.323,1.188 false 1.354,0.365 2.073,0.365 2.073,0.365 2.26,0.583 false 1.188,0.271 1.5,0.427 0.313,0.156 10 false *a 1.177,1.094 1.49,1.25 0.313,0.156 10 false *1
*1 Rear Disc Brake Cylinder Assembly
*a Clip


Disengage the clip and remove the No. 3 parking brake cable assembly.