2005-2008 RAV4 · Service Manual BRAKE

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  1. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

NOTICE:
When replacing the brake actuator or sensor, turn the ignition switch off.

Anti-lock brake system: 
Symptom
Suspected Area
See page
ABS and / or EBD does not operate
1. Check for DTCs again and make sure that normal system code is displayed.
Click here
2. IG power source circuit
Click here
3. Front speed sensor circuit
Click here
4. Rear speed sensor circuit
Click here
5. Check brake actuator using intelligent tester. (Check brake actuator operation using Active Test function.) If abnormal, check hydraulic circuit for leakage.
Click here
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
ABS and / or EBD does not operate efficiently
1. Check for DTCs again and make sure that normal system code is displayed.
Click here
2. Front speed sensor circuit
Click here
3. Rear speed sensor circuit
Click here
4. Stop light switch circuit
Click here
5. Check brake actuator using intelligent tester. (Check brake actuator operation using Active Test function.) If abnormal, check hydraulic circuit for leakage.
Click here
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
Sensor signal check cannot be performed
1. TS and CG terminal circuit
Click here
2. Brake actuator (skid control ECU)
Click here
DTC check cannot be performed
1. Check for DTCs again and make sure that normal system code is displayed.
Click here
2. TC and CG terminal circuit
Click here
3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
ABS warning light abnormal (Remains on)
1. ABS warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
ABS warning light abnormal (Does not come on)
1. ABS warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
BRAKE warning light abnormal (Remains on)
1. BRAKE warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
BRAKE warning light abnormal (Does not come on)
1. BRAKE warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
← PROBLEM SYMPTOMS TABLE (Nov 2005 – Dec 2006)PROBLEM SYMPTOMS TABLE (Aug 2007 – Jul 2008) →