C1429 Open or Short in Brake Pedal Load Sensing Switch
Diagnostic trouble codes · Vehicles built from Aug 2008
DESCRIPTION
The brake pedal load sensing switch operates when the brake pedal is depressed with force exceeding a predetermined level.The skid control ECU detects if the brake pedal is depressed or not via this circuit.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1429 |
An open or short in the brake pedal load sensing switch continues for 0.3 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
- HINT:
- When C1425 is output together with C1429, inspect and repair the trouble areas indicated by C1425 first (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (BRAKE PEDAL LOAD SENSING SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List mode on the intelligent tester (Click here).
ABS/VSC/TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Brake Pedal Load Sensing SW
Brake pedal load sensing switch / ON or OFF
ON: Brake pedal depressed beyond the specified point
OFF: Brake pedal not depressed beyond the specified point
-
Check that the brake pedal load sensing switch display observed on the intelligent tester changes according to brake pedal operation.
- OK:
- The intelligent tester displays ON or OFF according to brake pedal operation.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Perform the road and braking test.
Check if the same DTC is output (Click here).
- Result:
Result
Proceed to
DTC (C1429) is not output.
A
DTC (C1429) is output.
B
|
|
||||
| A | ||
| ||
| 3. INSPECT BRAKE PEDAL LOAD SENSING SWITCH |


- NOTICE:
- Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.
- Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
Turn the ignition switch off.
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Brake pedal load sensing switch off
(Brake pedal depressed)
0.9 to 1.1 kΩ
Brake pedal load sensing switch on
(Brake pedal released)
192 to 234 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
Make sure that there is no looseness in the locking part and connecting part of the connector.

Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A67-27 (FSW+) - A3-2
Always
Below 1 Ω
A67-27 (FSW+) - Body ground
Always
10 kΩ or higher
A3-1 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
