2005-2008 RAV4 · Service Manual BRAKE

VSC OFF Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2008

DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN communication system.
The VSC OFF indicator light illuminates to inform the driver when VSC OFF mode is entered using the VSC OFF switch.

WIRING DIAGRAM

C194134E05

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration (Click here).


1. PREPARE FOR INSPECTION
  1. Check that both of the following conditions are satisfied.

    1. The vehicle is not in VSC OFF mode.
    2. The vehicle is not in inspection mode.

      HINT:
      Confirm if the vehicle is in inspection mode or not by using the intelligent tester Data List.


NEXT


2. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



NG
REPAIR CAN COMMUNICATION SYSTEM (Click here)
OK


3. INSPECT SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


4. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← TRC OFF Indicator Light does not Come ON (from Aug 2008)VSC OFF Indicator Light does not Come ON (from Aug 2008) →