2005-2008 RAV4 · Service Manual BRAKE

VSC OFF Indicator Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2008

DESCRIPTION

Refer to the description of "VSC OFF Indicator Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the VSC OFF indicator light circuit (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC WARNING LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on the intelligent tester (Click here).

    ABS/VSC/TRC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC Warning Light
    VSC OFF indicator light
    Indicator light ON / OFF
    Observe the combination meter.

    OK:
    The VSC warning light turns on or off.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
NG


3. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← VSC OFF Indicator Light Remains ON (from Aug 2008)Slip Indicator Light Remains ON (Nov 2005 – Dec 2006) →