Home › STEERING › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptoms by checking the suspected areas in the order they are listed. Replace parts as necessary.


Steering lock system 
Symptom
Suspected Area
See page
Steering wheel cannot unlock (engine cannot start).
Entry and start system (for 1AZ-FE)
Click here
Entry and start system (for 2AZ-FE)
Click here
Entry and start system (for 3ZR-FAE)
Click here
Instrument panel junction block (Main body ECU)
Click here
Certification ECU
Click here
Steering lock motor drive power circuit
Click here
Power source circuit
Click here
Steering lock actuator (Steering lock ECU)
Click here
Unlock position sensor signal circuit
Click here
Steering wheel cannot unlock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO).
Entry and start system (for 1AZ-FE)
Click here
Entry and start system (for 2AZ-FE)
Click here
Entry and start system (for 3ZR-FAE)
Click here
ID code box
Click here
Instrument panel junction block (Main body ECU)
Click here
Certification ECU
Click here
LIN communication line
Click here
Steering wheel cannot lock.
Entry and start system (for 1AZ-FE)
Click here
Entry and start system (for 2AZ-FE)
Click here
Entry and start system (for 3ZR-FAE)
Click here
Instrument panel junction block (Main body ECU)
Click here
Certification ECU
Click here
Steering lock motor drive power circuit
Click here
Power source circuit
Click here
Steering lock actuator (Steering lock ECU)
Click here
Steering wheel cannot lock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO).
Entry and start system (for 1AZ-FE)
Click here
Entry and start system (for 2AZ-FE)
Click here
Entry and start system (for 3ZA-FAE)
Click here
ID code box
Click here
Instrument panel junction block (Main body ECU)
Click here
Certification ECU
Click here
LIN communication line
Click here