Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD) › 2012.12–2013.11
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049561 BRAKE BOOSTER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 85160 3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55081E 4.REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY

a.
C278610

Disengage the 3 clips and remove the cowl ventilator housing sub-assembly.


Hide 55701J 5.REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY

a.
C278592

Remove the 13 bolts and cowl top panel outer sub-assembly.


Hide 55736D 6.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

a.
C212147

Remove the 2 nuts and cowl body mounting reinforcement LH.


Hide 8.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47201 11.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 12.DISCONNECT VACUUM HOSE

a.

Slide the clip and disconnect the vacuum hose.


Hide 73900 13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55432B 14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

Hide 47101A 15.REMOVE BRAKE PEDAL RETURN SPRING

Hide 47264A 16.REMOVE PUSH ROD PIN

Hide 47264D 17.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the push rod clevis lock nut.


b.

Remove the push rod clevis.


Hide 44610 18.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C126454

Remove the 4 nuts.


b.

Pull out the brake booster with the brake booster gasket.


Hide 44785 19.REMOVE BRAKE BOOSTER GASKET

Hide 44730 20.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Remove the brake vacuum check valve assembly from the brake booster.


Hide 44696 21.REMOVE CHECK VALVE GROMMET

a.

Remove the check valve grommet from the brake booster.


Hide 89420H 22.REMOVE VACUUM SENSOR ASSEMBLY (for 1AD-FTV)

a.

Remove the vacuum sensor from the brake booster.


Hide 44696 23.REMOVE VACUUM SENSOR GROMMET (for 1AD-FTV)

a.

Remove the vacuum sensor grommet from the brake booster.