36100
1.REMOVE TRANSFER ASSEMBLY
17118
2.REMOVE MANIFOLD STAY
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE INTAKE / EXHAUST>EXHAUST MANIFOLD>REMOVAL
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE INTAKE / EXHAUST>EXHAUST MANIFOLD>REMOVAL
43457
3.REMOVE DRIVE SHAFT BEARING BRACKET
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
31105H
4.REMOVE TRANSAXLE CASE OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, pry out the front transaxle case oil seal.
Tape the screwdriver tip before use.
41311R
5.REMOVE FRONT DIFFERENTIAL CASE OIL SEAL
Using SST, remove the front differential case oil seal.
Be careful not to damage the differential case.
41311R
6.INSTALL FRONT DIFFERENTIAL CASE OIL SEAL
Coat the lip of a new front differential case oil seal with MP grease.
| *a | 21.5 to 22.5 mm (0.847 to 0.885 in.) |
Using SST and a hammer, tap in a new front differential case oil seal to the front transaxle case.
21.5 to 22.5 mm (0.847 to 0.885 in.)
Do not damage the front differential case oil seal lip.
31105H
7.INSTALL TRANSAXLE CASE OIL SEAL
Coat the lip of a new transaxle case oil seal with MP grease.
| *a | 5.5 to 6.5 mm (0.217 to 0.255 in.) |
Using SST and a hammer, tap in a new transaxle case oil seal to the front transaxle case.
5.5 to 6.5 mm (0.217 to 0.255 in.)
Do not damage the transaxle case oil seal lip.
43457
8.INSTALL DRIVE SHAFT BEARING BRACKET
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
17118
9.INSTALL MANIFOLD STAY
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE INTAKE / EXHAUST>EXHAUST MANIFOLD>INSTALLATION
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE INTAKE / EXHAUST>EXHAUST MANIFOLD>INSTALLATION
36100
10.INSTALL TRANSFER ASSEMBLY