1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
11212
4.REMOVE NO. 2 CYLINDER HEAD COVER
17705
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
74404A
8.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28800
9.REMOVE BATTERY
74431
10.REMOVE BATTERY TRAY
16057
11.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
74411B
12.REMOVE FRONT BATTERY BRACKET
74414B
13.REMOVE BATTERY BRACKET REINFORCEMENT
50819
14.REMOVE FRONT FLOOR COVER
58910C
15.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
16.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
|
Disconnect in this Direction |
Disconnect the end of the transmission control cable assembly from the shift lever assembly.
| *1 | Stopper |
| *2 | Nut |
|
Turn in this Direction |
|
Pull out in this Direction |
Pull out the stopper of the transmission control cable assembly.
Turn the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.
Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.
33820B
17.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the nut and disconnect the transmission control cable assembly from the transmission control cable support.
Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting insulator.
Remove the 2 bolts and transmission control cable assembly.