Home › Drivetrain › EB61F MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY › 2015.10–2016.08
RM3090E _52 Drivetrain _008758 EB61F MANUAL TRANSMISSION / TRANSAXLE _0050281 MANUAL TRANSAXLE ASSEMBLY A

EB61F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.


PROCEDURE

Hide 28100 2.REMOVE STARTER ASSEMBLY (for 3ZR-FE)

Hide 28100 3.REMOVE STARTER ASSEMBLY (for 3ZR-FAE)

Hide 30300 4.REMOVE MANUAL TRANSAXLE ASSEMBLY

a.

Disconnect the engine wire.

i.
C341827

Disconnect the clamp and back-up light switch connector.


ii.
C341829

w/ Stop and Start System:

Disconnect the neutral position switch connector and 2 clamps.



b.
C277914

Remove the 8 bolts and manual transaxle assembly.


Hide 12311A 5.REMOVE FRONT ENGINE MOUNTING BRACKET

a.
C197778

Remove the 4 bolts and front engine mounting bracket.


Hide 12325A 6.REMOVE ENGINE MOUNTING BRACKET LH

a.
C200440

Remove the 4 bolts and engine mounting bracket LH.


Hide 12321A 7.REMOVE REAR ENGINE MOUNTING BRACKET

a.
C277913

Remove the 4 bolts and rear engine mounting bracket.


Hide 31490 8.REMOVE CLUTCH ACCUMULATOR ASSEMBLY

Hide 31407B 9.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

Hide 31400 10.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

Hide 33403K 11.REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY

a.
C206813

Remove the bolt and speedometer driven hole cover sub-assembly from the manual transaxle case.


b.

Remove the O-ring from the speedometer driven hole cover sub-assembly.


Hide 36100 12.REMOVE TRANSFER ASSEMBLY

Hide 36100A 13.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT


a.
C299942

Remove the 2 transfer and transaxle setting stud bolts.

HINT:

It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.



Hide 14.REMOVE WIRE HARNESS CLAMP BRACKET

a.
C341830

for Front of Vehicle:

Remove the bolt and wire harness clamp bracket.


b.
C341831

for Rear of Vehicle (w/ Stop and Start System):

Remove the bolt and wire harness clamp bracket.