Home › Engine / Hybrid System › 2WW FUEL › FUEL FILTER › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221825 FUEL FILTER A

2WW FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

When replacing the fuel filter element, use TOYOTA genuine parts.

·

When replacing the fuel filter element, clean the fuel filter case and remove dirt completely.



PROCEDURE

Hide 55781E 1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)

Hide 55784D 2.REMOVE COWL TOP VENTILATOR LOUVER (for LHD)

a.
A362719

Detach the 5 clows to remove the cowl top ventilator louver.


Hide 17880 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY

Hide 23941 5.REMOVE NO. 1 FUEL FILTER PROTECTOR

a.
A362573

Rmove the 2 nuts and No. 1 fuel filter protector.


Hide 6.REMOVE FUEL FILTER ELEMENT

a.
A362574

Disconnect the No. 1 fuel hose and No. 3 fuel hose from the fuel filter assemly.

Click hereEngine / Hybrid System>2WW FUEL>FUEL SYSTEM>PRECAUTION


b.
A362570

Put a container under the fuel filter assembly.


c.

Loosen the drain cock to drain fuel.


d.

Tighten the drain cock.


e.
A362575

Disengage the lock, pull down the lever and disconnect the fuel heater connector.


f.
A362576

Using a 24 mm deep socket wrench, remove the fuel filter cap from the fuel filter case.


g.

Remove the fuel filter element from the fuel filter case.


h.
A362720

Remove the O-ring from the fuel filter cap.


Hide 7.INSTALL FUEL FILTER ELEMENT

a.

Clean the fuel filter case and remove dirt completely.


b.

Install a new O-ring to the fuel filter cap.


c.

Install the fuel filter element to the fuel filter case.


d.

Using a 24 mm deep socket wrench, install the fuel filter cap to the fuel filter case.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


e.

Connect the fuel heater connector and lock with the lever.


f.

Connect the No. 1 fuel hose and No. 3 fuel hose to the fuel filter assemly.

Click hereEngine / Hybrid System>2WW FUEL>FUEL SYSTEM>PRECAUTION


Hide 23941 8.INSTALL NO. 1 FUEL FILTER PROTECTOR

a.

Install the No. 1 fuel filter protector with the 2 nuts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)


Hide 17880 10.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY

Hide 55784D 11.INSTALL COWL TOP VENTILATOR LOUVER (for LHD)

a.

Attach the 5 claws to install the cowl top ventilator louver.


Hide 55781E 12.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)