The circuit is used to send TRC/TRAC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1203 | ECM Communication Circuit Malfunction | Either of the following is detected:
1.
Engine model information sent from the ECM does not match the information stored in the skid control ECU. 2.
No system information stored in the skid control ECU. 3.
Incorrect installation of the skid control ECU or ECM. |
·
ECM malfunction or ECM with incorrect part number installed ·
Skid control ECU (Brake actuator assembly) |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check that the proper ECM is installed.
| Proceed to |
|---|
| Proper ECM is installed |
| Proper ECM are not installed (for 2AD-FHV) |
| Proper ECM are not installed (for 2AD-FTV) |
| Proper ECM are not installed (for 2AR-FE) |
| Proper ECM are not installed (for 3ZR-FAE) |
| Proper ECM are not installed (for 3ZR-FE) |
| Proper ECM are not installed (for 2WW) |
Proper ECM is installed
Proper ECM are not installed (for 2AD-FHV)
Proper ECM are not installed (for 2AD-FTV)
Proper ECM are not installed (for 2AR-FE)
Proper ECM are not installed (for 3ZR-FAE)
Proper ECM are not installed (for 3ZR-FE)
Proper ECM are not installed (for 2WW)
Check if the brake actuator assembly had been replaced before the DTC was recorded.
| Proceed to |
|---|
| The brake actuator assembly is not replaced |
| The brake actuator assembly is replaced |
The brake actuator assembly is not replaced
The brake actuator assembly is replaced
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Check if the same DTC is recorded.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC C1203 is not output |
| DTC C1203 is output |
DTC C1203 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC C1203 is output
Perform initialization and calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Check if the same DTC is recorded.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC C1203 is not output |
| DTC C1203 is output |
DTC C1203 is not output
DTC C1203 is output