Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0226194 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The ECM sends signals such as A/T information signals, dynamic radar cruise control operation signals and brake operation demand signals to the skid control ECU (brake actuator assembly) when the dynamic radar cruise control is operating. The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the skid control ECU (brake actuator assembly) detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1631 Communication Error from ECM to VSC While the vehicle speed is 40 km/h (25 mph) or more and the dynamic radar cruise control system is operating (vehicle-to-vehicle distance control mode), if the ECM continuously receives a logical error signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

Communication circuit

·

ECM

·

Skid control ECU (brake actuator assembly)



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check that the CAN communication system is functioning normally.

OK:

CAN communication system is functioning normally.


HINT:

Refer to CAN Bus Check for the CAN communication system.

for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>DIAGNOSIS SYSTEM

for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>DIAGNOSIS SYSTEM



Result:
Proceed to
OK
NG



OK

2.REPLACE ECM

NG

2.REPLACE ECM

NEXT

3.CHECK FOR DTCs
3.CHECK FOR DTCs
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Turn the ignition switch to ON.

2.

Turn the dynamic radar cruise control system on using the cruise control switch (ON/OFF).

3.

Drive the vehicle at 40 km/h (25 mph) or more for 1 second or more.




d.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


e.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

i.

for 2AD-FHV, 2AD-FTV:

Powertrain > Radar Cruise1 > Trouble Codes
50001 74

ii.

for 2AR-FE, 3ZR-FE, 3ZR-FAE:

Powertrain > Radar Cruise1 > Trouble Codes
50001 239

iii.

for 2WW:

Powertrain > Cruise Control > Trouble Codes
50001 391


Result:
Result Proceed to
DTC P1631 is not output A
DTC P1631 is output B



A

END

B