Home › Engine / Hybrid System › 2AD-FTV COOLING › RADIATOR › from 2015.10
RM3090E _51 Engine / Hybrid System _008373 2AD-FTV COOLING _0046727 RADIATOR A

2AD-FTV COOLING  RADIATOR  REMOVAL  


PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 51441 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 52119A 7.REMOVE FRONT BUMPER COVER

Hide 52618 9.REMOVE FRONT LOWER BUMPER ABSORBER

a.
A295910

Remove the 4 screws and front lower bumper absorber.


Hide 74404A 11.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28899 12.REMOVE BATTERY INSULATOR

Hide 28800 13.REMOVE BATTERY

Hide 74431 14.REMOVE BATTERY TRAY

Hide 74411B 15.REMOVE FRONT BATTERY BRACKET

Hide 74414B 16.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 86520 17.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 86510 18.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 52085 19.REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY

a.
A295911

Remove the 2 bolts, clip and front bumper center stay sub-assembly.


Hide 52029 20.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY

A295912

a.

Remove the 2 bolts and front bumper upper reinforcement sub-assembly.


Hide 16681A 21.REMOVE UPPER RADIATOR AIR GUIDE PLATE

a.
A362601

Remove the 6 clips and upper radiator air guide plate.


Hide 16683A 22.REMOVE LOWER RADIATOR AIR GUIDE PLATE

a.
A362602

Detach 3 claws and remove the lower radiator air guide plate.


Hide 88625P 23.DISCONNECT AMBIENT THERMISTOR ASSEMBLY

a.
A297519

Detach the clamp to disconnect the ambient thermistor assembly.


Hide 52131A 24.REMOVE FRONT BUMPER REINFORCEMENT

Hide 88703 25.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

A295916

a.

Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.


b.

Remove the O-ring from the discharge hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88706 26.DISCONNECT LIQUID TUBE SUB-ASSEMBLY

A295915

a.

Remove the bolt and disconnect the liquid tube sub-assembly from the cooler condenser assembly.


b.

Remove the O-ring from the liquid tube sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 16691A 27.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

a.
A362605

Detach 3 claws and remove the front radiator side air guide plate RH.


Hide 16693A 28.REMOVE REAR RADIATOR SIDE AIR GUIDE PLATE RH

a.
A295920

Remove the 2 clips and rear radiator side air guide plate RH.


Hide 16695A 29.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH

a.
A362604

Detach 3 claws and remove the front radiator side air guide plate LH.


Hide 16697A 30.REMOVE REAR RADIATOR SIDE AIR GUIDE PLATE LH

a.
A295919

Remove the 2 clips and rear radiator side air guide plate LH.


Hide 25770A 31.DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY

A295964

a.

Slide the clip and disconnect the No. 2 vacuum transmitting hose assembly from the intake manifold.


Hide 16533B 32.REMOVE NO. 1 RADIATOR SUPPORT

a.
A300882

Remove the 2 bolts and 2 No. 1 radiator supports.


b.

Remove the 2 radiator support cushions.


Hide 16261G 33.REMOVE NO. 1 WATER BY-PASS HOSE

a.
A295970

Slide the 2 clamps and disconnect the No. 1 water by-pass hose from the radiator reservoir assembly and radiator hose sub-assembly.


b.

Detach the hose clamp from the upper radiator support.


c.

Remove the 2 bolts and disconnect the water by-pass hose clamp bracket from the upper radiator support.


Hide 34.DISCONNECT WIRE HARNESS

a.
A362591

w/ Towing Package:

Disconnect the 3 connector and detach the 11 clamps.


b.
A295922

w/o Towing Package:

Disconnect the 4 connector and detach the 13 clamps.


Hide 53216A 36.REMOVE UPPER RADIATOR SUPPORT

a.
A295967

Remove the 4 bolts and upper radiator support.


Hide 16057 37.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

Hide 16572D 38.DISCONNECT NO. 2 RADIATOR HOSE

Hide 17342F 39.REMOVE INTERCOOLER AIR HOSE

a.
A295921

Loosen the 2 hose clamps.


b.

Remove the intercooler air hose from the No. 1 air tube and intercooler assembly.


Hide 16400 41.REMOVE RADIATOR ASSEMBLY

a.
A297515

for Automatic Transaxle

i.

Detach the hose clamp from the oil cooler hose sub-assembly.


ii.

Slide the 3 hose clips and disconnect the 3 oil cooler hoses.



b.

Remove the radiator assembly and 2 cushions.


Hide 16533 42.REMOVE NO. 2 RADIATOR SUPPORT

a.
A300883

Remove the 4 bolts and 2 No. 2 radiator supports.


Hide 88460 43.REMOVE COOLER CONDENSER ASSEMBLY

a.

Remove the cooler condenser assembly.


Hide 25770A 44.REMOVE NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Detach the 4 clamps from the fan shroud and No. 2 air tube.


b.
A295972

Slide the 2 clips and remove the No. 2 vacuum transmitting hose assembly from the intercooler assembly and No. 2 air tube.


Hide 17362B 45.REMOVE NO. 2 AIR TUBE

a.
A295973

Loosen the hose clamp.


b.

Remove the bolt and No. 2 air tube from the intercooler assembly.


Hide 16057 46.REMOVE RADIATOR HOSE SUB-ASSEMBLY

a.
A295974

Disconnect the 2 clamps from the fan shroud.


b.

Slide the 2 clamps and remove the radiator hose sub-assembly from the radiator assembly.


Hide 16572D 47.REMOVE NO. 2 RADIATOR HOSE

A295975

a.

Slide the clamp and remove the No. 2 radiator hose from the radiator assembly.


Hide 32906 48.REMOVE OIL COOLER TUBE SUB-ASSEMBLY (for Automatic Transaxle)

a.
A295976

Slide the 2 clips and disconnect the 2 oil cooler hoses from the radiator assembly.


b.

Remove the 2 bolts and oil cooler tube sub-assembly from the fan shroud.


Hide 16535 49.REMOVE LOWER RADIATOR SUPPORT

Hide 17940D 50.REMOVE INTERCOOLER ASSEMBLY

Hide 16711 51.REMOVE FAN SHROUD

a.
A295977

Remove the 3 bolts and fan shroud.