| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| 015 | Operating Block caused by Overheating | The control overheating sensor detects overheating of the engine coolant, and the power heater ECU stops the operation of the heater assembly. (DTCs 012 and/or 014 are detected 10 times in a row.) | ·
Engine coolant circuit (leaks, engine coolant quality, thermostat, water pump assembly) ·
Heater assembly |
Clear the DTCs by pressing the memory clear buttons on the tester to unlock the ECU.
Check for engine coolant leaks.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the engine coolant quality.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the thermostat.
Inspect the thermostat.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the water pump assembly.
Inspect the water pump assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG