Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU) › from 2016.08
RM3090E _57 Power Source / Network _008434 NETWORKING _0221951 CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU) T

NETWORKING  CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING



Result List of How to Proceed with Troubleshooting
Symptom Suspected Area Link
Open in CAN Main Bus Line Open in CAN Main Wire Click here
Short in CAN Bus Lines Short in CAN Bus Lines Click here
Short to +B in CAN Bus Line Short to B+ in CAN Bus Line Click here
Short to GND in CAN Bus Line Short to GND in CAN Bus Line Click here
Open in One Side of CAN Branch Line Open in One Side of CAN Branch Line Click here

HINT:

Refer to How to Proceed with Troubleshooting for the Bus Check procedure. the DTCs output from ECUs connected to the CAN communication system.


The suspected communication stop area can be determined based on the ECU or sensor that was not displayed in CAN Bus Check and by referring to the table below.

Communication Stop Mode Table
Symptom Suspected Area Link
"Skid Control (ABS/VSC/TRAC)" is not displayed on GTS Skid Control ECU Communication Stop Mode Click here
"Air Conditioning Amplifier" is not displayed on GTS Air Conditioning Amplifier Communication Stop Mode Click here
"Power Steering (EPS)" is not displayed on GTS Power Steering ECU Communication Stop Mode Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on GTS Steering Angle Sensor Communication Stop Mode Click here
"ECM (Engine)" is not displayed on the GTS ECM Communication Stop Mode Click here
"Main Body" is not displayed on the GTS Main Body ECU Communication Stop Mode Click here
"Combination Meter" is not displayed on the GTS Combination Meter ECU Communication Stop Mode Click here
"Airbag" is not displayed on the GTS Center Airbag Sensor Communication Stop Mode Click here
"Stop and Go/Start" is not displayed on the GTS (w/ Stop and Start System) Engine Stop and Start ECU Communication Stop Mode Click here
"Four Wheel Drive Control" is not displayed on the GTS (for 4WD/AWD) 4WD Control ECU Communication Stop Mode Click here
"Display and Navigation (AVN1)" is not displayed on the GTS (w/ Audio and Visual System [for Radio and Display Type]) Audio Receiver Assembly Communication Stop Mode Click here
"DCM" is not displayed on the GTS (w/ Telematics Transceiver) DCM Communication Stop Mode Click here

DTC Combination Table
Symptom Suspected Area Link
Although CAN communication (V bus) is currently normal, ECUs connected to the V bus store CAN communication DTCs The probable part for which communication is interrupted can be determined using DTC Communication Table and comparing the DTCs output from ECUs connected to the CAN communication system Click here