The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch master cylinder removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/o Occupant Classification System)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for M20A-FKS:General>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE BRAKE BOOSTER
4.DRAIN CLUTCH FLUID
Wash brake fluid off immediately if it adheres to any painted surface.
31481
5.LOOSEN CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench, loosen the clutch master cylinder to flexible hose tube.
Use a container to collect the fluid.
31453A
6.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
7.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY
31434E
8.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE
Slide the hose clip and disconnect the No. 1 clutch reservoir hose from the clutch master cylinder assembly.
Use a container to collect the fluid.
31481
9.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.
Use a container to collect the fluid.
31410
10.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
Remove the clutch master cylinder assembly.
31415
11.REMOVE CLUTCH MASTER CYLINDER GASKET
Remove the clutch master cylinder gasket from the clutch master cylinder assembly.