Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.
The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using a reflector.
The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-2.2°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.
1.INSTALL BLIND SPOT MONITOR SENSOR LH
|
Nut |
|
Connector |
Connect the connector.
Install the 3 nuts and blind spot monitor sensor LH.
Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.
2.INSTALL BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
3.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION
4.INSTALL REAR BUMPER ASSEMBLY
5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Hands Free Power Back Door)
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
6.INSTALL BATTERY HOLE COVER (for HV Model, w/ Hands Power Back Door System)
58416K
7.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model, w/ Hands Power Back Door System)
58410B
8.INSTALL DECK BOARD ASSEMBLY (for HV Model, w/ Hands Power Back Door System)
9.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT
10. PERFORM DIAGNOSTIC SYSTEM CHECK
891B2
11.INSPECT KICK DOOR CONTROL SENSOR (w/ Hands Free Power Back Door)
for HV Model:
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for HV Model)>OPERATION CHECK
for Gasoline Model:
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for Gasoline Model)>OPERATION CHECK
12. INITIALIZE POWER BACK DOOR SYSTEM (w/ Hands Free Power Back Door)
for HV Model:
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for HV Model)>INITIALIZATION
for Gasoline Model:
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for Gasoline Model)>INITIALIZATION
13.PERFORM CALIBRATION (w/ Parking Support Brake System)
for Gasoline Model: