Home › Drivetrain › K120 (MULTIDRIVE / CVT) › TCM › 2018.10–2020.08
RM3620E _52 Drivetrain _076272 K120 MULTIDRIVE / CVT _0371728 TCM A

K120 MULTIDRIVE / CVT  TCM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during TCM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
TCM If transaxle compensation code read from TCM
·

Transfer transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:(Click here)
for Registration:(Click here)
If transaxle compensation code not read from TCM
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53895B 3.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

Hide 53896B 4.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH

Hide 51441 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51420 6.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 53737D 7.REMOVE FRONT FENDER APRON SEAL LH

Hide 89535B 8.REMOVE TCM

a.
C400622

Remove the bolt to disconnect the engine wire from the No. 2 transmission control ECU bracket.


b.
C400623C02
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw, rotate the lever and disconnect the TCM connector.


c.
C400625

Remove the 2 bolts and TCM from the continuously variable transaxle assembly.


Hide 89539M 9.REMOVE NO. 1 TRANSMISSION CONTROL ECU BRACKET

a.
C399924

Remove the 2 screws and No. 1 transmission control ECU bracket from the TCM.


Hide 89539N 10.REMOVE NO. 2 TRANSMISSION CONTROL ECU BRACKET

a.
C399925

Remove the 2 screws and No. 2 transmission control ECU bracket from the TCM.