The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during eco-run vehicle converter assembly removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE FRONT BUMPER ASSEMBLY
for Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Off Road Package)>REMOVAL
except Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>REMOVAL
G92C0A
4.REMOVE ECO-RUN VEHICLE CONVERTER ASSEMBLY
| *a | Lock Lever |
Move the lock lever and disconnect the connector from the eco-run vehicle converter assembly.
Remove the 2 nuts and eco-run vehicle converter assembly.
F1334
5.REMOVE NO. 1 CONVERTER CONTROL BRACKET
Remove the 2 bolts and No. 1 converter control bracket from the eco-run vehicle converter assembly.