The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
Use the same procedure described for the LH side.
When performing removal for the front door belt moulding, disconnect the negative (-) auxiliary battery terminal after fully opening the front door glass.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
58410B
2.REMOVE DECK BOARD ASSEMBLY (for HV Model)
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)
65351A
4.REMOVE BATTERY HOLE COVER (for HV Model)
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
for A25A-FKS:
for M20A-FKS:
Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69278B
6.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
74642A
7.REMOVE FRONT DOOR ASSIST GRIP COVER LH
8.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
9.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67602
10.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
11.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
68193C
12.REMOVE FRONT DOOR FRONT BELT SEAL LH
67832
13.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
14.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
67664C
15.REMOVE DOOR FRAME GARNISH LH
68151D
16.REMOVE FRONT DOOR GLASS RUN LH
67402F
17.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH
68126
18.REMOVE FRONT DOOR FIX WINDOW GLASS LH
75712B
19.REMOVE FRONT DOOR BELT MOULDING LH
|
Protective Tape |
Apply protective tape around the front door belt moulding LH.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While pressing the front door belt moulding LH, pull the edge and detach the claw as shown in the illustration.
|
Remove in this Direction |
Detach the claw as shown in the illustration to remove the front door belt moulding LH.