The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electric vehicle battery plug assembly removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
G3834
1.REMOVE SERVICE PLUG GRIP
82111
2.DISCONNECT ENGINE ROOM MAIN WIRE
3.REMOVE CONNECTOR COVER ASSEMBLY
4.CHECK TERMINAL VOLTAGE
5.INSTALL CONNECTOR COVER ASSEMBLY
82111
6.CONNECT ENGINE ROOM MAIN WIRE
7.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
72693
8.REMOVE REAR SEAT CUSHION LOCK HOOK
67918E
9.REMOVE REAR DOOR SCUFF PLATE LH
58467H
10.REMOVE NO. 3 BATTERY SERVICE COVER BOARD
67917C
11.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
58466J
12.REMOVE NO. 2 BATTERY SERVICE COVER BOARD
58464D
13.REMOVE BATTERY SERVICE COVER BOARD
71033
14.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G92N4A
15.REMOVE NO. 1 HV BATTERY COVER PANEL RH
G3830A
16.REMOVE ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Disconnect the electric vehicle battery plug assembly connector.
Disengage the 2 claws and open the wiring harness protector.
Disconnect the HV battery junction block assembly connector.
Insulate the disconnected high-voltage connector with insulating tape.
Disconnect the hybrid battery terminal block connector.
Insulate the disconnected high-voltage connector with insulating tape.
Remove the bolt and electric vehicle battery plug assembly from the HV battery.