CHASSIS > GENERAL MAINTENANCE |
| 1. INSPECT POWER STEERING FLUID LEVEL |
Check the power steering fluid level (Click here).
| 2. INSPECT STEERING LINKAGE AND GEAR HOUSING |
Check the steering wheel free play (Click here).
Check the steering linkage for looseness or damage.
Check that the tie rod ends do not have excessive play.
Check that the dust seals and boots are not damaged.
Check that the boot clamps are not loose.
Check that the steering gear housing is not damaged.
Check that the connectors are properly connected to the steering gear housing.
| 3. INSPECT BALL JOINT AND DUST COVER |
Inspect the ball joints for excessive looseness.
Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.
Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.
Using a lever, pry up the end of the lower arm. Check the amount of play.
Check the dust cover for damage.
| 4. INSPECT DRIVE SHAFT BOOTS |
Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.
| 5. CHECK AUTOMATIC TRANSMISSION FLUID |
Visually check the transmission for fluid leakage. If oil is leaking, find the cause and repair it.
| Type | See Procedures |
| AB60E |
Click here
|
| AB60F |
Click here
|
| 6. REPLACE AUTOMATIC TRANSMISSION FLUID |
| Type | See Procedures |
| AB60E |
Click here
|
| AB60F |
Click here
|
| 7. INSPECT TRANSFER OIL (for 4WD) |
Inspect the transfer oil (Click here).
| 8. REPLACE TRANSFER OIL (for 4WD) |
Replace the transfer oil (Click here).
| 9. INSPECT FRONT DIFFERENTIAL OIL (for 4WD) AND REAR DIFFERENTIAL OIL |
Inspect the rear differential oil (Click here).
| 10. REPLACE FRONT DIFFERENTIAL OIL (for 4WD) AND REAR DIFFERENTIAL OIL |
Replace the differential oil (Click here).
| 11. INSPECT FRONT AND REAR SUSPENSION |
| Type | See Procedures |
| Front |
Click here
|
| Rear |
Click here
|
| 12. LUBRICATE PROPELLER SHAFT (for 4WD) |
Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.
for Front propeller shaft

for Rear propeller shaft

| 13. TIGHTEN BOLTS PROPELLER SHAFT |
Tighten the bolts of the propeller shaft.
| Type | See Procedures |
| Front propeller shaft |
Click here
|
| Rear propeller shaft (for 2WD) |
Click here
|
| Rear propeller shaft (for 4WD) |
Click here
|