The distance control ECU receives information about the area in front of the vehicle from the laser radar sensor and then sends a brake control demand signal (deceleration demand) and diagnosis signals, such as laser radar sensor grime signals or laser radar sensor malfunction signals, to the ECM.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1615 | While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is logically inconsistent for 0.5 seconds, the ECM records this logical error code | ·
Communication circuit ·
Distance control ECU ·
ECM |
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.
When the distance control ECU and ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>INITIALIZATION).
Replace the distance control ECU (See page Engine / Hybrid System>CRUISE CONTROL>DISTANCE CONTROL ECU>REMOVAL).
NEXT
Perform initialization (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>INITIALIZATION).
Turn the ignition switch to ON.
Turn the cruise control main switch on.
With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.
Do not turn the light control switch on at this time because the beam axis automatic adjustment mode has already started, which could lead to incorrect beam axis. If the light control switch is turned on by mistake, readjust the beam axis (refer to Beam Axis Adjustment) (See page Engine / Hybrid System>CRUISE CONTROL>LASER SENSOR>ADJUSTMENT).
If initialization cannot be performed, first inspect the stop light switch circuit, cruise main switch circuit, and skid control buzzer circuit.
NEXT
Clear the DTC (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
NEXT
Reproduce the DTC detection conditions under which the DTC is stored.
If the DTC detection conditions are not correct, the system will not detect the trouble.
Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for 3UR-FE) | B |
| DTC is output (for 3UR-FBE) | C |
A
B
C