Home › Engine / Hybrid System › CRUISE CONTROL › DISTANCE CONTROL ECU
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235641 DISTANCE CONTROL ECU A

CRUISE CONTROL  DISTANCE CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62312B 5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 53601 7.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55046A 8.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 9.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 82733A 10.SEPARATE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

Hide 88240A 11.REMOVE DISTANCE CONTROL ECU ASSEMBLY

E141174

a.

Disconnect the connector.


b.

Remove the bolt and the distance control ECU.