Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1. TABLE OF BOLT, SCREW AND NUT
2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
3. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
51441
5.REMOVE NO. 1 ENGINE UNDER COVER
6. DRAIN ENGINE COOLANT (for 3UR-FE)
7. DRAIN ENGINE COOLANT (for 3UR-FBE)
88716B
8.REMOVE COOLER REFRIGERANT LIQUID PIPE B
Remove the bolt, and slide the hook connector.
Disconnect the suction pipe and liquid pipe.
Do not use a screwdriver or similar tool to disconnect the pipe.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Remove the 2 O-rings from the suction pipe and liquid pipe.
87245A
9.REMOVE HEATER WATER INLET HOSE A
Using pliers, grip the claws of the clip and slide the clip to disconnect the water hose.
Do not apply excessive force to the rear heater outlet water hose.
Prepare a drain pan or cloth in case the coolant leaks.
87246A
10.REMOVE HEATER WATER OUTLET HOSE A
Using pliers, grip the claws of the clip and slide the clip to disconnect the water hose.
Do not apply excessive force to the rear heater inlet water hose.
Prepare a drain pan or cloth in case the coolant leaks.
85211B
11.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
85221B
12.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
53866J
13.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
53867H
14.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
55781E
15.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
16.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
45186
17.REMOVE LOWER NO. 2 STEERING WHEEL COVER
45187
18.REMOVE LOWER NO. 3 STEERING WHEEL COVER
45130
19.REMOVE STEERING PAD
45100
20.REMOVE STEERING WHEEL ASSEMBLY
45287
21.REMOVE LOWER STEERING COLUMN COVER
45286B
22.REMOVE UPPER STEERING COLUMN COVER
84140
23.REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
67914
24.REMOVE FRONT DOOR SCUFF PLATE LH
62112
25.REMOVE COWL SIDE TRIM BOARD LH
62312C
26.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62212
27.REMOVE FRONT PILLAR GARNISH LH
55318C
28.REMOVE INSTRUMENT SIDE PANEL LH
53601
29.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55046A
30.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
73900
31.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
33504F
32.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58804A
33.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
58925A
34.REMOVE REAR CONSOLE BOX POCKET
58805C
35.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
58815A
36.REMOVE CONSOLE BOX CARPET
58910C
37.REMOVE REAR CONSOLE BOX ASSEMBLY
58811A
38.REMOVE FRONT CONSOLE BOX
55410C
39.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
83100
40.REMOVE COMBINATION METER ASSEMBLY
55434B
41.REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL
84010D
42.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
86120
43.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (w/o Navigation System)
44.REMOVE NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)
55317A
45.REMOVE INSTRUMENT SIDE PANEL RH
67913
46.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
47.REMOVE COWL SIDE TRIM BOARD RH
62311C
48.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62211
49.REMOVE FRONT PILLAR GARNISH RH
55607
50.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55312
51.REMOVE LOWER INSTRUMENT PANEL
73990
52.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
55045A
53.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
55042B
54.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55409A
55.REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
86160P
56.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY LH
55409F
57.REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
86160P
58.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY RH
55474E
59.REMOVE NO. 3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
86160L
60.REMOVE FRONT NO. 4 SPEAKER ASSEMBLY (for 14 Speakers)
71910A
61.REMOVE FRONT SEAT HEADREST ASSEMBLY (for LH Side)
72138E
62.REMOVE SEAT TRACK INNER COVER LH (for LH Side)
72138D
63.REMOVE SEAT TRACK OUTER COVER LH (for LH Side)
71200S
64.REMOVE FRONT LH SEAT ASSEMBLY (for LH Side)
71910A
65.REMOVE FRONT SEAT HEADREST ASSEMBLY (for RH Side)
72137C
66.REMOVE SEAT TRACK INNER COVER RH (for RH Side)
72137G
67.REMOVE SEAT TRACK OUTER COVER RH (for RH Side)
71100S
68.REMOVE FRONT RH SEAT ASSEMBLY (for RH Side)
86183D
69.REMOVE AUDIO AMPLIFIER COVER (for 14 Speakers)
86280
70.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY (for 14 Speakers)
87212G
71.REMOVE REAR NO. 3 AIR DUCT
Remove the clip.
Detach the 4 claws and remove the air duct.
87212H
72.REMOVE REAR NO. 4 AIR DUCT
Remove the clip.
Detach the 4 claws and remove the air duct.
87201F
73.REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY
45220
74.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
Put matchmarks on the steering intermediate shaft and the steering column.
Remove the bolt and separate the steering intermediate shaft from the steering column.
45250
75.REMOVE STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
45250
76.REMOVE STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)
55301
77.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for 14 Speakers)
55301
78.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for 8 Speakers)
33820B
79.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
33550
80.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
87212
81.REMOVE REAR NO. 1 AIR DUCT
Detach the 3 claws and remove the air duct.
87212F
82.REMOVE REAR NO. 2 AIR DUCT
Detach the 3 claws and remove the air duct.
82733A
83.SEPARATE MAIN BODY ECU
Disconnect the connectors and clamp.
Remove the bolt and nut and separate the main body ECU.
81980
84.REMOVE TURN SIGNAL FLASHER ASSEMBLY
Disconnect the connector.
Remove the nut and the turn signal flasher.
82861
85.REMOVE NO. 1 ECU INTEGRATION BRACKET
Disconnect the connectors and clamp.
Remove the bolt and nut and the ECU integration bracket.
55330B
86.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY
Disconnect the connectors and clamps and separate the wire harness.
Remove the bolt and disconnect the ground wire.
Remove the instrument panel reinforcement.
for Driver Side:
Remove the 2 caps and 3 bolts.
for Passenger Side:
Using a T40 "TORX" socket, remove the 2 "TORX" bolts.
When removing the bolts, the collars may come off with the bolts.
for Passenger Side:
Using a 12 mm hexagon wrench, remove the 2 collars.
Remove the 3 bolts, nut and instrument panel reinforcement.
Disconnect the connector and clamp and separate the wire harness.
87.REMOVE FRONT AIR CONDITIONING UNIT
Remove the 3 bolts, 2 screws and the air conditioning unit.