1.DRAIN TRANSFER OIL
37110
2.REMOVE PROPELLER SHAFT ASSEMBLY
33309C
3.REMOVE REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
36115C
4.REMOVE TRANSFER CASE REAR OIL SEAL
Using SST, tap out the oil seal.
Do not damage the oil-seal-fitted surface of the rear extension housing.
36115C
5.INSTALL TRANSFER CASE REAR OIL SEAL
Apply transfer oil to the spline area of the output shaft.
Using SST and a hammer, tap in a new oil seal until its surface is flush with the housing upper surface.
33309C
6.INSTALL REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
37110
7.INSTALL PROPELLER SHAFT ASSEMBLY
8.ADD TRANSFER OIL
9.CHECK TRANSFER OIL
10.INSPECT FOR TRANSFER OIL LEAK