Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235712 AIR SUSPENSION SYSTEM C

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  C1784  Steering Angle Sensor Communication Error  


DESCRIPTION

The steering angle sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, this DTC is stored by the diagnosis function.

DTC Code Detection Condition Trouble Area
C1784 A steering angle sensor or steering angle sensor power source malfunction signal is detected for 5 seconds or more.
·

Steering angle sensor

·

Steering angle sensor power source circuit

·

Suspension control ECU



WIRING DIAGRAM

C214176E12
1.938,0.917 2.792,1.281 0.854,0.365 10 false from Battery 1.938,1.875 2.927,2.26 0.99,0.385 10 false from IG Circuit 5.479,0.917 5.802,1.083 0.323,0.167 10 false BAT 5.5,1.875 5.719,2.083 0.219,0.208 10 false IG 0.573,3.417 2.177,3.781 1.604,0.365 10 false Suspension Control ECU 1.615,4.271 6.438,4.469 4.823,0.198 10 false : CAN Communication System 5.188,3.479 6.635,3.865 1.448,0.385 10 false Steering Angle Sensor 0.583,3.25 0.927,3.417 0.344,0.167 10 false O16 5.198,0.833 5.323,1.01 0.125,0.177 10 false 3 5.198,1.792 5.344,1.948 0.146,0.156 10 false 1 3.656,1.083 4.188,1.438 0.531,0.354 10 false ECU-B1 3.458,2.021 4.427,2.406 0.969,0.385 10 false ECU-IG NO. 1 5.177,3.323 5.458,3.49 0.281,0.167 10 false H6 5.479,2.438 5.917,2.615 0.438,0.177 10 false ESS 5.198,2.323 5.396,2.521 0.198,0.198 10 false 2

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



HINT:

If DTC C1782 is output at the same time as C1784, perform troubleshooting for C1782 first (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>C1782).


PROCEDURE

1.CHECK DTC

b.

Perform a road test.


c.

Check if DTCs C1784 and U0126 are output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Condition Proceed to
DTC is not output or only DTC C1784 is output A
DTCs C1784 and U0126 are output B



A

2.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

B

2.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for steering angle sensor malfunction DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Condition Proceed to
DTC is not output A
DTC is output B



A

3.CHECK TERMINAL VOLTAGE AND RESISTANCE (IG, BAT, ESS)

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

3.CHECK TERMINAL VOLTAGE AND RESISTANCE (IG, BAT, ESS)
a.

Disconnect the H6 steering angle sensor connector.


b.
U153739E02
1.073,2.188 1.073,2.604 true 0.854,2.198 0.573,2.615 true 1.271,2.198 1.604,2.604 true 1.479,2.646 1.802,2.802 0.323,0.156 10 false BAT 0.448,2.646 0.625,2.813 0.177,0.167 10 false IG 0.927,2.625 1.26,2.802 0.333,0.177 10 false ESS 0.104,0.052 2.49,0.844 2.385,0.792 10 false Front view of wire harness connector (to Steering Angle Sensor) 1.656,1.156 1.875,1.313 0.219,0.156 10 false H6

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H6-1 (IG) - Body ground Ignition switch ON 11 to 14 V
H6-3 (BAT) - Body ground Always 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
H6-2 (ESS) - Body ground Always Below 1 Ω



c.

Check that the steering angle sensor connector is not deformed or corroded.

OK:

No deformation or corrosion.




OK

4.READ VALUE USING TECHSTREAM (STEERING ANGLE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.READ VALUE USING TECHSTREAM (STEERING ANGLE)
a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the Techstream on.


e.

Enter the following menus: Chassis / Air suspension / Data List.

Air Suspension
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Steering Angle Steering angle sensor reading /
Min.: -49152.0 deg
Max.: 49150.5 deg
Actual steering angle
Left turn: reading increases
Right turn: reading decreases
-

OK:

Steering wheel turning angle value changes when steering wheel is turned.




OK

REPLACE SUSPENSION CONTROL ECU

NG