Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM27L0U _54 Brake _049321 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0235735 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1336/39  Zero Point Calibration of Acceleration Sensor Undone  


DESCRIPTION

A new skid control ECU is supplied without zero point calibration for the deceleration sensor and master cylinder pressure sensor. Until the zero points are calibrated, DTC C1336/39 remains stored. By entering test mode, the zero point calibration is automatically performed, and DTC C1336/39 is cleared automatically.

DTC Code DTC Detection Condition Trouble Area
C1336/39 When the vehicle is driven without completion of zero point calibration.
·

Zero point calibration incomplete

·

VSC actuator (skid control ECU)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the VSC actuator assembly, perform the zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


HINT:

When U0123/62, U0124/69 or U0126/63 is output together with C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/69 or U0126/63 first.


PROCEDURE

1.CHECK SENSOR USING TEST MODE PROCEDURE

b.

Check if any of the test mode DTCs are recorded.

Result
Result Proceed to
DTC (test mode DTC) is not output A
DTC (test mode DTC) is output B



A

2.CHECK YAW RATE SENSOR INSTALLATION

B

2.CHECK YAW RATE SENSOR INSTALLATION
a.

Check that the yaw rate sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION).

OK:

The sensor is tightened to the specified torque.

The sensor is not tilted.




OK

3.PERFORM DECELERATION SENSOR ZERO POINT CALIBRATION

NG

INSTALL YAW RATE SENSOR CORRECTLY

3.PERFORM DECELERATION SENSOR ZERO POINT CALIBRATION
a.

Perform zero point calibration of the deceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).



NEXT

4.RECONFIRM DTC
4.RECONFIRM DTC

b.

Start the engine.


c.

Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B

HINT:
·

The DTC is set if the zero point calibration has not been completed successfully.

·

End the procedure when the same DTC is not set after completion of the zero point calibration.





A

B